|
Product Description |
Cement based, one component, water resistance gas concrete mortar which has high stability and is used to bond gas concrete blocks and bricks where are manufactured in different sizes. |
|
Ürün No |
304 |
|
Areas of Usage |
• For vertical and horizontal applications at inside and outside parts of the buildings
• It is used for walling process of constructional components such as all kinds of gas concrete, porous brick and limestone brick. |
|
Product Advantages
|
-
Used in indoor and outdoor locations,
-
Easy to prepare and apply, long operation time,
-
Can be used in horizontal or vertical surfaces securely,
-
After removing its cure, resistant to water and frost,
-
Resistant against impact and vibrations, highly adhesive.
|
|
Technical Data |
|
Powder Color |
|
Grey |
|
Package |
|
Craft sacks of 25 kg |
|
Pot life |
|
Approximately 3 hours |
|
Surface Operation Time |
|
Approximately 10-15 minutes |
|
Application Equipment |
|
10x10x10 (mm) toothed comb |
|
Operation temperature |
|
Surface temperature +5°C / +25°C |
|
Pressure Endurance |
|
>5 N/mm² |
|
Storage |
|
Its shelf life is approximately 12 months. Products should be stored in a cool and dry environment provided that maximum 6 bags will be put on top of each other. |
|
|
Consumption |
 |
|
Preparing the Surface
|
The floor, on which there will be application, should be cleaned of all loose parts, oil and other chemicals and the defects on the surface are repaired with first line classic mortar by being bought to scale. This process is not necessary for the other lines.
|
|
Instructions for Preparing
|
(25 kg) powder material is poured into 7-8 liters (it may vary depending on air temperature) of clean and cool mixing water and with a low-speed and suitable mixer, a smooth homogeneous mixture is obtained in 3-4 minutes. Water shouldn’t be added to powder material.
After resting the mixture for 3-5 minutes it is stirred again and applied on gas concrete with the same thickness and combed. Right after, gas concrete blocks (within 10-15 minutes) are placed on the surface and tamped. During the process of walling, horizontal and vertical joint should be left and the joints should be 3 mm. maximum. Joint intervals should be filled completely with the prepared mixture. |
|
Points to take into Consideration |
Do not use mortar whose exposure time has expired or become crusted. Hardened mortar shouldn’t be watered.
|
